Extron Electronics DMP 44 LC User Guide - Manual (Page 77)

3. Install blank panels or other units on the rack shelf.
Furniture Mounting
Furniture mount the DMP 44 LC using the optional mounting kit (Extron MBU 123, part
number 70-212-01, as follows:
1. Attach the selected mounting brackets with the machine screws provided.
2. If feet were previously installed on the bottom of the cabinet, remove them.
3. Hold the unit with the attached brackets against the underside of the table or other
furniture, or against the wall. Mark the location of the screw holes of the bracket on
the mounting surface.
4. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.4 mm) deep in the mounting
surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4 inch of the head of the screw protrudes.
6. Align the mounting screws with the slots in the brackets and place the unit against
the surface, with the screws through the bracket slots.
7. Slide the unit slightly forward or back, then tighten all four screws to secure it in
place.
QuarterRackUnderdeskMounting
Figure 35. MBU 123, Under-Desk Mounting
DMP 44 LC • Reference Information 71