Extron Electronics DMP 44 LC User Guide - Manual (Page 69)

When a preset is being previewed, in either Live or Emulate mode, the Delete button
is available. In Live mode, the preset is deleted from the hardware, which is reflected in
software (it is removed from the preset list). After disconnecting from the device and
before exiting the program, the file must then be saved to retain this change. In Emulate
mode, the preset is deleted from the file in software, which must then be saved (before
exiting) to retain this change. In either Live or Emulate mode, the Cancel button
defeats the preview action and returns the user to the current state or current emulation,
respectively.
Presets: Pull vs. Push or Create Live
When a preset is pulled from the device, the preset data remains in the device until the
preset has been recalled. DSP Configurator pulls only the names of the presets. These
presets cannot be saved to disk until they have been recalled.
An asterisk next to the preset name indicates that only the preset name has been pulled
from the device, and the preset data only exists in the device (it has not been recalled).
Presets pushed to the device or created in DSP Configurator while in Live mode have no
asterisk. Presets with no asterisk can be saved to disk.
DMP 44 LC • Software Control 63