Asus P505 - Manual (Page 302)

10-18 P505 Smart PDA Phone
Infrared (IR) connection Infrared (IR) connection Infrared (IR) connection Infrared (IR) connection Infrared (IR) connection
By default, your device detects incoming infrared (IR) beams and
prompts you to accept them. If you do not want your device to
detect or receive beams, clear the Receive all incoming beams
Receive all incoming beams Receive all incoming beams Receive all incoming beams Receive all incoming beams
check box.
To set the Beam options: To set the Beam options: To set the Beam options: To set the Beam options: To set the Beam options:
1. Tap , then Settings Settings Settings Settings Settings.
2. Tap the Connections Connections Connections Connections Connections tab.
3. Tap the Beam Beam Beam Beam Beam icon to display
the Settings screen.
Ending a connection Ending a connection Ending a connection Ending a connection Ending a connection
Use the following methods to end a network connection.
• When connected via modem or VPN, tap on the navigation
bar, then tap Disconnect Disconnect Disconnect Disconnect Disconnect.
• When connected via cable or cradle, detach your device from the
cable or cradle.
• When connected via Infrared, move the device away from the
other computer or device.
• When connected via a network (Ethernet) card, remove the card
from your device.
• When connected to a wireless network using an SDIO Wi-Fi card,
switch off the connection.