GE Industrial Solutions Entellisys Integrator’s Guide - Manual (Page 19)

19
Modbus Memory Map
NOTE: A multiplier factor may be necessary in cases where an integer value is returned but the Range and/or Step imply a
greater precision. In these cases, it is necessary to divide the returned value by 10 for a step of "0.1" or "0.5"; by 100 for a step of
".01"; and so on. Similarly, it is necessary to multiply by these factors prior to writing a settings value. This note does
not apply
to any step value greater than 1 (a step of "10" does not require a multiplier, for example). This note also does not apply to
values returned in floating point format. See the format codes at the end of the map for more information.
NOTE: Discrete I/O output state registers (Contact Output x State – register range from x9180 to x91FF and Contact Output
States – register range from xB256 to 0xB25D) contain correct information only when FlexLogic Active register (x0034) contains
value 1 (yes).
Addr Register Name Range Units Step Format Factory Default
Product Information (Read Only)
0000 Product Type 0 to 2 --- 1 F716
0 (Low Voltage
Switchgear)
0001 Serial Number --- --- --- F203 "0"
0009 External Ethernet MAC Address --- --- --- F072 0
000C Reserved (3 items) --- --- --- F001 0
000F CPU Hardware Version 0 to 655.35 --- 0.01 F001 100
0010 CPU Firmware Version 0 to 655.35 --- 0.01 F001 100
0011 CPU Firmware Boot Code Version 0 to 655.35 --- 0.01 F001 100
0012 Build Date --- --- --- F200 "0"
0026 Synchronizer Board Status 0 to 1 --- 1 F102 0 (Disabled)
0027 Synchronizer Board Frequency Setting 50 to 60 Hz 10 F001 60
0028 Last Energy Clear Date 0 to 4294967295 --- 1 F050 0
002A Last CPU Commissioned Date 0 to 4294967295 --- 1 F050 0
002C Expected Node Protocol Version 0 to 655.35 --- 0.01 F001 0
002D Summary Number --- --- --- F205 "0"
0033 Line Up 0 to 99 --- 1 F001 1
0034 FlexLogic Active 0 to 1 --- 1 F126 0 (No)
0035 Reserved (203 items) --- --- --- F001 0
Installation (Read/Write Setting)
0100 CPU ID 0 to 1 --- 1 F717 0 (CPU A)
0101 CPU Commissioned 0 to 1 --- 1 F102 0 (Disabled)
0102 CPU Name --- --- --- F200 "UNNAMED"
0116 System Frequency 50 to 60 Hz 10 F001 60
0117 Phase Rotation 0 to 1 --- 1 F106 0 (ABC)
0118 Reserved (232 items) --- --- --- F001 0
Clock (Read/Write Command)
0200 RTC Set Time 0 to 4294967295 --- 1 F050 0
Clock (Read Only)
0202 Date Time Changed 0 to 4294967295 --- 1 F050 0
0204 Reserved (8 items) --- --- --- F001 0