GE Industrial Solutions GE ZENITH SERIES MDU - Manual (Page 5)

Receiving Your MDU
GE Z ENITH C ONTROLS
MDU Owner’s Manual
601 S HILOH R OAD January 2013
Plano, TX 75074 Page 5
2.0 Receiving Your MDU
2.1. Receiving and Unpacking Instructions
GE carefully packages every MDU to ensure damage-free delivery to your job site. GE recommends
the following unpacking procedures be followed upon delivery.
1. Inspect packaging, exterior panels, and doors for any visible damage (i.e. scratches dents,
cracks, or torn packaging). If any damage exists, please call the GE Service Team at (800) 637-
1738.
2. Remove the outer layer of protective shrink wrap from the unit.
3. Carefully cut the safety bands, making sure that they do not scrape the exterior of the unit or
scratch the paint. Use eye, face, and hand protections to guard against injury when bands are
cut.
4. At this point, your unit is ready to be removed from the pallet using a fork-lift truck. Use extreme
caution to ensure the unit is properly centered on the forks.
5. Once the unit is completely off the pallet and ramp, carefully remove the under layer of
protective shrink wrap.
6. Ensure that the casters both rotate and can roll freely so as not to damage the flooring.
7. The unit is now ready to be rolled into its final position and prepared for installation. Please refer
to the Installation Procedures listed on page 8 before proceeding.
8. If any further assistance is needed, please call the GE Service Team at (800) 637-1738.
Note: The MDUs should not be loosened from the shipping pallet until all handling by a forklift or
pallet jack is completed. Complete internal inspection should be done only after
equipment positioning and prior to electrical hookup.
Note: Any damages must be noted on the bill of laden with a detailed description of the
damages incurred. A claim will need to be filed with the freight company at the time of
delivery. Failure to properly document all damages may result in the unit’s warranty
being voided.