SENA Rhio10 - Manual (Page 76)

76
if ipmode = static,
par1 = IP address, par2 = subnet mask, par3 = gateway
if ipmode = dhcp,
no parameters required
if ipmode = pppoe,
par1 = PPPoE username, par2 = PPPoE password
To configure IP configuration parameters of the RHIO10, use set command as follows:
set ip static ip_address subnet_mask default_gateway +
where,
ip_address = IP address of the RHIO10
subnet_mask = Subnet mask
default_gateway = Default gateway IP address
To apply changes, users have to invoke ‘save’ and ‘reboot’ command after changing
configuration.
> set ip static 192.168.1.10 255.255.255.0 192.168.1.1
OK
> set ip dhcp
OK
>
> set ip pppoe pppoeuser pppoepassword
OK
>
B.3.2 Host Mode Configuration
Basic ‘set’ command usage for host mode configuration is as follows:
set host hostmode par1 par2 ...
where,
hostmode: tcps=TCP server / tcpc=TCP client / tcpsc=TCP server & client
parameters:
if hostmode = TCP server (tcps),
par1 = listening TCP port,