SENA Rhio10 - Manual (Page 16)

16
Probe
Users may probe the Rhio10 on the network. If users perform [Probe] command, then the
Rhio10 detected will be shown on the Probe screen. If users select the one in the Probe screen,
then they are asked to enter ID and Password. Users are able to configure the Rhio10’s
parameters within the Get/Set screen.
Set
After users complete the configuration, they have to click [Set] button to reflect the changes.
Once it is done, the changes will be stored on to the flash memory and the system will be
rebooted.
Reboot
Users may reboot the Rhio10 by using the botton. In this case, the TCP connection is
disconnected, whereas the I/O management status is still maintained.
I/O PORT CONTROL
Users may monitor, control and configure the Rhio10’s I/O ports by clicking [I/O PORT
CONTROL] button.