beautypg.com

4 restoring factory default – SENA Rhio10 User Manual

Page 31

background image

31

Figure 3-9 System Administration Configuration

3.4 Restoring Factory Default

Users may restore the Rhio10 parameters into factory default value by pressing factory reset

switch on the hole of Rhio10 side panel. They will have to put the sharp pin into the hole and

press it for around 1 sec to reset the Rhio10. Rhio10 will be rebooted after the operation.

The following is the factory default value of the parameters.

IP Mode:

DHCP

Host Mode:

TCP Server, TCP port 6001

ID / Password:

admin / admin

Device Name:

Rhio10 Device

I/O Port status:

Enable

Power-out Post Recovery: Enable

ADC Operation Mode : Level Mode

ADC Threshold value : 512

Output Port operation condition : None

Run/Stop status : Run

See also other documents in the category SENA Computer Accessories: