Grain Systems PNEG-1851 - Manual (Page 78)

Appendix A: Grain Drying Operations
11.Increase the plenum temperature to your normal operating temperature.
12.Continue unloading in manual mode for a minimum of five to seven minutes for each point of mois-
ture you need to remove.
13.Turn the Unload Auger switch to Auto.
Initial Settings for Full-Heat and Dry and Cool
Once the wet grain’s moisture content has been measured during the initial run, you can set the drying
time and unload speed according to the drying operation’s respective table below.
For details on when to use these initial settings, see Drying Grain in the Initial Run, page 32 .
Table A-1 Initial settings for the full-heat operation
Unload speed in manual mode
Initial
moisture
Drying time
(min.)
One-module
dryer (bph)
Two-module
dryer (bph)
Three-
module dryer
(bph)
17% 16 630 990 990
18% 21 480 990 990
19% 26 390 810 990
20% 32 320 670 990
21% 37 270 570 860
22% 42 240 510 770
23% 47 210 450 680
24% 51 200 410 620
25% 54 180 390 590
26% 58 170 360 550
27% 62 160 340 510
28% 67 150 320 480
29% 72 140 300 450
30% 76 130 280 420
31% 81 120 260 390
32% 86 120 250 370
33% 91 110 230 350
34% 96 100 220 330
35% 100 100 210 320
78 PNEG-1851 Vision N2