Configuring user preferences – Grain Systems PNEG-1851 User Manual
Page 28
NOTE: The Configuration Status dialog box is displayed in certain situations, most notably upon
startup and after clearing shutdown messages. It remains active for a few seconds before
closing automatically.
4. Once the software is ready, click the Start Software button.
If the touchscreen is calibrated, the software starts immediately and the main menu is displayed. If
not calibrated, the Touchscreen Calibration window automatically opens. Follow the onscreen instruc-
tions to successfully calibrate the touchscreen.
IMPORTANT: If the screen is too slow in reacting or your touches seem to be constantly off target,
you can calibrate the touchscreen by accessing the Touchscreen Calibration sub-
menu in the System menu. The Touchscreen Calibration submenu is not accessible
when you are operating the dryer via GSI’s remote web application.
After You Finish
With the controller turned on, proceed as follows:
• If configuring your controller for the first time, see
Configuring User Preferences, page 28
.
• If performing pre-season tests, click System→Control (Advanced)→Board Mode and select Pre-
season Mode (see
for details on this mode).
• If drying grain, see
Drying Grain in the Initial Run, page 32
.
IMPORTANT: If the dryer detects a fault with one or more of its components upon startup, the correspond-
ing shutdown messages are displayed onscreen. Correct them immediately before starting
the dryer.
Configuring User Preferences
Once you power on the dryer, you can set user preferences such as the system’s language and its clock,
so that onscreen content appears as desired and system logs are accurate.
To configure user preferences:
1. From the taskbar, click System→Preferences→Language.
2. Set the following parameter:
Language — The system’s language. Content in all menus and submenus appear in this language.
3. Click Save.
IMPORTANT: To store your settings, make sure to click Save before closing the active window.
28
PNEG-1851 Vision N2