Grain Systems PNEG-1851 - Manual (Page 52)

Chapter 5: The Drying Modes
Figure 5-11 Time and temperature control scheme in the dry and cool operation
NOTE: In full-heat operation, the cooling phase is simply bypassed. As a result, the unloading phase
starts immediately following the drying phase, allowing uncooled, hot grain to be discharged from
the dryer.
Selecting a Drying Mode
Before drying grain, you can select a drying mode to determine how wet grain passes through the dryer
and exits as dry grain.
To select a drying mode:
1. From the menu pane, click Control→Moisture Control Mode.
2. Select one of the following parameters:
Continuous Flow — A drying mode where grain enters and exits the dryer in one continuous, unin-
terrupted cycle.
Staged Batch — A drying mode comprised of three distinct phases, where only a portion of the grain
is loaded, dried, and unloaded at a single time.
The available control schemes for each drying mode are displayed in the Drying Control Scheme
field.
After You Finish
For information on the continuous flow control schemes, see Drying Grain in Continuous Flow, page 57 ;
for staged batch, see Drying Grain in Staged Batch, page 63 .
52 PNEG-1851 Vision N2