Grain Systems PNEG-1851 User Manual
Page 39
• Make sure to set the interval and sampling rate settings through either the Dryer Data: Table View or
Dryer Data: Graph View windows (see
Monitoring Grain and Dryer Data in Real Time, page 38
• Make sure that the dryer is powered on.
• Make sure that the USB (Universal Serial Bus) flash drive is formatted to FAT32 (32-bit File Allocation
Table).
To download dryer data to a USB flash drive:
1. Open the control panel door and locate the single-board computer (SBC) board.
CAUTION
Use extreme caution when opening the control panel door with the dryer
powered on. To avoid electrical shock and potential damage to the board, do not
touch the board with tools or with your hands when inserting the USB flash drive
into a USB port.
2. Insert the USB flash drive in an available USB port on the SBC board then return to face the control
panel.
A message notifying you that the downloading process is set to begin is displayed onscreen. The
data that is downloaded is that which is present in the database at the time of download.
IMPORTANT: Do not remove the USB flash drive until the transfer is complete.
3. Once a message notifying you that the download was successful is displayed onscreen, remove the
USB flash drive.
A compressed data file (ZIP) that contains a file in the comma separated value (CSV) format is saved
to your USB flash drive.
4. Close the control panel door and make sure that it is secure.
After You Finish
Transfer the data to your personal computer or local network, so that you can compile and track grain and
dryer information.
PNEG-1851 Vision N2
39