beautypg.com

Fb244: send component – VEGA VEGACOM 557 Profibus FMS User Manual

Page 29

background image

VEGACOM 557 Profibus FMS

29

Setup

Dat administration:
Bit 4: Data acceptance running
Bit 5: Data transfer being effected
Bit 6: Data acceptance being effected
Bit 7: Disable data block

Failure message:
0: No failure
1: Wrong type information in the functional component
2: Storage area not available
3: Storage area too small
4: Delayed acknowledgement
5: Failure in the indication word
6: Invalid source/destination parameters
A: Connection error
B: Handshake error
C:System error
D:Blocked data block
E: Order cannot be processed
F: Connection or ANR not specified

FB244: SEND component

This functional component gives a transmission command to the CP. The CP initiates the
PROFIBUS FMS Read service to read out the measured values

FB244: SEND
Parameter

Format

Description

Example

SSNR

KY

Interface number

KY 0,0

A-NR

KY

Order number

KY 0,1

ANZW

MW

Indication value

MW 2

QTYP

KC

Source type: Data component

KC DB

DBNR

KY

Data component number

KY 0,240

QANF / ZANF

KY

Relative initial address within the type

KY +20

QLAE / ZLAE

KF

Number of source/destination data

KF +15

PAFE

MB

Parameter setting error

MB 255

In the example, an order is given to the CP. The order block describes the CP order and can
be found in the data component DB240 from data word DW20 with a length of 15 data words.
The parameters ANZW and PAFE deliver status and failure information for processing (here
MW2 or MB 255).