VEGA VEGACOM 557 Profibus FMS - Manual (Page 18)

18 VEGACOM 557 Profibus FMS
Setup
4 Setup
In this section, all measures you need to take to set up your VEGACOM 557 in conjunction with
the Siemens communication processor CP5431 are described. If your PROFIBUS master is an
instrument from another manufacturer, please observe the necessary measures found in the
respective manufacturer documentation.
In the setup procedure, the parameters of the communication processor must be set first. To
do this, the STEP5/ST basic package, as well as the NCM program (Network and Communi-
cation Management) from Siemens, is required (note: Siemens is running the Profibus under
the name "L2-Bus").
For the reading in of measurement data through VEGACOM 557 PROFIBUS FMS, the three
functional components FB 210, FB 211, FB 212 are used, which have to be integrated in your
S5 application. The components described in this section are available on the diskette in the
file [email protected].
4.1 Setup check list
1 Check hardware requirements
- PC or S5 programming device
- A connection between PC/programming device and CP5431 and AG through signal con-
verter, e.g. Köster-Box with connection cable to PC and to CP/AG
- Siemens automation device (AG) S5 with power supply component
- Siemens communication processor CP5431 as Profibus master
- VEGACOM 557 version PROFIBUS FMS
2 Check software requirements
- Siemens STEP5/ST basic package
- Siemens additional module NCM (Network and Communication Management)
- VEGACOM 557 Profibus diskette: S5 application "Read in VEGACOM measured values"
(file: [email protected])
3 Carry out adjustments on VEGACOM 557
- Baud rate via DIL switch
- Address via DIL switch
- Connection resistance via hook switches
4 Carry out parameter setting of CP5431
- Basic planning
- Network parameters
- FMS planning (connection planning)
5 Transfer parameter database to CP5431 and activate by switching off/on the voltage
supply (power supply component)