Ohaus E1M110 Explorer Balances - Manual (Page 41)

41
P P P P P Print display data
Field: Weight Mode Stab CR LF
Length: 9 1 5 1 1 1
When "numeric only"data is
selected for output in the
RS232 menu, the Mode field
is not output.
xSL xSL xSL xSL xSL Set stable data only printing (set x = 0 to 3). If LFT 0 or 1.
T T T T T Same effect as pressing O/T button.
V V V V V Print EPROM version
Esc V Esc V Esc V Esc V Esc V Print balance ID (13 characters).
xZ xZ xZ xZ xZ Set Auto Zero to “x”,where x = 0 to 3 ). 0=Off, 1=0.5d, 2=1d, 3=5d.If LFT,
programs Auto zero level from 0 to 1.
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
C C C C C Begin span calibration
xD xD xD xD xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
F F F F F Print current function.
x x x x x IIIII Set Averaging Filter Level to “x”,
where x = 0 to 3 (see table).
If LFT, level 0 to 1.
L L L L L Begin linearity calibration
xM xM xM xM xM Places balance in mode “x”,
where x = 1 to 17 (see table).
If unit or mode is not already
enabled, command will be ignored.
RS232 COMMAND TABLE (Cont.)
0 = minimum level
1 =
2 =
3 = maximum level
1 = (not used)
2 = grams
3 = kilo grams
4 = dwt
5 = Carats
6 = Ounces
7 = Ounces troy
8 = Grains
9 = Taels Hong Kong
10 = Taels Singapore
11 = Taels Taiwan
12 = Mommes
13 = Decimal Pounds
14 = (Not used)
15 = Newton's
16 = tical
17 = Custom Units
Same as ?
command
Displayed weight sent right justified
w/lead zero blanking.
Nine characters include:
decimal point (1)
weight (7 max)
polarity (1): blank if positive
"-" if negative