Ohaus E1M110 Explorer Balances - Manual (Page 25)

25
3.8 Weigh Below
The Explorer balance is equipped with a weigh below hook which can be attached to the bottom of the balance. To
install the hook, remove the protective cap from the bottom of the balance as shown in the figure below. Screw the
weigh below hook into the bottom of the balance.
3.9 Printing Data
Printing data to an external computer or printer requires that the communications parameters in the Setup menu,
Print options and communication parameters be set first. Refer to page 23 Print menu settings and page 25 for
RS232 communication settings.
Procedure
• Press the Print button. Printing to an external printer
or computer will occur each time the Print button is
pressed unless autoprint feature is turned on in which
case printing can occur in a continuous fashion, at
specified intervals or each time a stable reading is
achieved.
Sample printout is shown below with time turned on.
SAMPLE PRINTOUT
For a review of of printing samples, refer to Section 4
Setting Up Your Balance. What is printed is controlled
by the GLP Set Menu and the selection of GLP Cont.
or GLP Tare in the Print Menu.
1/01/97 12:01:37 AM
429.5 g