Ohaus E1M110 Explorer Balances - Manual (Page 28)

28
4.3 Good Laboratory Practices (GLP) Data
The GLP Data submenu enables the storage of a user identification number (7 digits) and/or a project number
(digits). When entered into the balance, the identification number and project number are available when printing
providing they are turned on in the GLP Set submenu. A lock setting is also available which locks in the user identifi-
cation and project number.
Procedure
To select any of the items in the GLP Data menu, pro-
ceed as follows:
• Press the Setup button, CAL is displayed.
• Press or button until GLP DATA is displayed.
• Press Enter button to continue.
• Press or button until either USER NO,
PROJ NO, LOCK or EXIT is displayed.
• Press Enter button to continue.
• Press or buttons as directed by
the display and enter a 7 digit number for the user ID
number.
• Press Enter button to save setting.
• Press or button until either USER NO,
PROJ NO, LOCK or EXIT is displayed.
• Press Enter button to continue.
• Press or buttons as directed by
the display and enter a 7 digit number for the project
number.
• Press Enter button to save setting.
• Press or button to select next item or EXIT.
• Press Enter button to continue.
4.4 Good Laboratory Practices (GLP) Set
Good Laboratory Practices (GLP) Set submenu allows the selection and will permit printing of Time, Balance Identifi-
cation Number, User Identification Number, Project Number, Difference and Name data to be printed. When the
selected items are set to ON, these items are not displayed. The default setting is OFF. When an external printer is
used, and all items are set ON and the balance is calibrated, the printer will print out calibration data for audit trail
purposes and will indicate date, and time. (It should be noted that the User ID number and Project number must be
entered in the GLP Data submenu before printed data is available).
• Press the Setup button, CAL is displayed.
• Press or button until GLP SET is displayed.
• Press Enter button to continue.
• Press or button until either TIME, BAL ID,
USER NO, PROJ NO, DIFF, NAME, LOCK or EXIT is
displayed.
• Press Enter button to continue.
• Press or button and select either ON or
OFF.
• Press Enter button to save setting.
• Press or button to select next item or EXIT.
• Press Enter button to continue.
Procedure
To select any of the items in the GLP Set menu, proceed
as follows: