Ohaus E1M110 Explorer Balances - Manual (Page 38)

38
4.12 Menu Lock-Out Protection
Access to the various menus can be disabled setting the Lockswitch located on the PC board inside the balance to
OFF position. The Lockswitch locks out all menus which have had Lock turned ON. The default setting for the
Lockswitch is OFF. The Lockswitch access is located on the bottom of the balance.
LFT Switch Location and Sealing Method Top Sealing Location and Method
Type Approved/Legal for Trade
Balance Sealing
AlL Voyager balances may be sealed for type approved/
legal for trade applications. Type Approved balances are
sealed as shown in the figures.
For type approved balances consult local Weights and
Measures officials to determine sealing method require-
ments.
After the balance has been set up properly and LFT is set
ON, proceed to seal the balance as shown below.
Procedure
• Turn the display off and unplug the power cord.
• Turn the balance over, make sure the pan does not
fall off.
• The Lockswitch can be accessed through the hole
nearest the front panel as shown in the illustration
below.
• Remove the plastic cover from the hole nearest the
front panel.
• Select the desired position on the Lockswitch and
reassemble the balance. Use a small screwdriver to
reach the switch.
• Replace the plastic cover in the switch access hole.
• Turn the balance over and plug in the power cord.