M&C TechGroup PMA 50 EEX Operator's manual - Manual (Page 6)

6
Gas sampling and gas conditioning technology 9-3.15-ME
3 ELECTRICAL STANDARDS
The electrical standard of electrical equipment corresponds to the safety regulations concerning
the EN61010 and to the safety requirements of the European standards EN 61508; EN 50014 :
1997, EN 50018 : 2000, EN 50019 : 2000, EN 50020 : 2002 and EN 50284 : 1999 for operation of
the equipment in hazardous areas group II category 2. Attention must be paid to the Certificate of
Conformity KEMA 03 ATEX 2215X (see appendix).
4 SAFETY INSTRUCTIONS
Please note the following basic safety procedures when using this equipment:

Read these operating instructions carefully before start-up and use of the equipment! The
information and warnings given in these operating instructions must be heeded.

Attention must be paid to the requirements of the certificate of conf ormity (see appendix):
KEMA 03 ATEX 2215X.

Work on electrical equipment is only to be carried out by trained specialists as per the
regulations currently in force.

Attention must be paid to the requirements of VDE 0100 when setting high-power electri-
cal units with nominal voltages of up to 1000V, together with the associated standards
and stipulations.

For use in hazardous area observe the relevant national and international instructions and
regulations.

Check the details on the type plate to ensure that the equipment is connected up to the
correct mains voltage.

Protection against touching dangerously high electrical voltages. Before opening the
equipment, it must be switched and hold no voltages. This also applies to any external
control circuits that are connected.

The equipment is only to be set within the permitted range of temperatures and pre s-
sures.

Check that the location is weather-protected. It should not be subjected to either direct
rain or moisture.

Installation, maintenance, monitoring and any repairs may only be done by authorised
personnel with respect to the relevant stipulations.