M&C TechGroup PMA 50 EEX Operator's manual - Manual (Page 25)

25
Gas sampling and gas conditioning technology 9-3.15-ME
19 MEASURING
For the first starting up at a new location, the afore mentioned steps have to be performed.
The interval of the new calibration is defined by the requirements of precision.
After having chosen the desired measuring range, the analyser is ready to operate.
D A N G E R !
The sample gas must be free from all liquid or solid particles, i.e.
the dew point of the gas must be significantly below the equipment
temperature so that no condensate will occur inside the equip-
ment. If necessary, lower the dew point by means of a cooler or
dryer. For dust filtration use a filter of 2 micron porosity !
We will be pleased to inform you about an optimal gas conditioning!
N O T E !
Basically measurements should be carried out only with flow quan-
tity and room temperature held constant.