EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 90)

Issue
11.01.C
nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
82
Process
To regenerate the timecode in a given playlist, proceed as follows:
1. Activate the TC Regeneration and define the related settings on the Playlist page
( F10), in the blue-highlighted area at the bottom of the page. This feature is defined
for each playlist individually:
2. Activate the internal loop using the SHIFT+LOOP keys
3. Roll the playlist.
This will record the playlist back into the recorder channel 1 (CAM A) with the
regenerated timecode.
Activating the Continuous Timecode
Regeneration
To activate the continuous timecode regeneration, proceed as follows:
1. In the Playlist page (
F10), press several times until the ON/OFF field after
‘Regeneration of TC’ is green highlighted.
2. Press the right arrow key to toggle the function to ‘ON’.
The continuous timecode regeneration function is now active. However, the timecode will
effectively be regenerated when you replay the playlist after activating a loop. To
deactivate the function, press the left arrow on the field to toggle the function to ‘OFF’.
Settings for Continuous Timecode in Playlists
The following table describes the various parameters that should be defined when
regenerating the timecode in a playlist:
Parameter Description Possible Values
Continuous in … Specifies whether the timecode should
be continuous for the whole playlist or
for each playlist element.
PLST, CLIP
From … Specifies the initial TC value to be used
for the timecode regeneration
Timecode, LTC TC,
User TC
In … Specifies the TC type in which the
timecode should be regenerated
LTC or VITC in SD
HANC VITC, HANC
LTC or both