Edit all, Insert, Speed – EVS XTnano Version 11.01 - November 2012 Operation Manual User Manual

Page 79: Fx dur, Effect, Delete

nano series Servers - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

Issue

11.01.C

clip, simply browse to the requested clip, then select a function from the menu displayed

above and use the control lever to adjust to the desired value (when applicable).

Edit All

If you want to edit all clips of the playlist at the same time, select

Edit All (SHIFT+D)

before you perform the requested editing action with one of the following playlist

commands:

Speed, Effect, FX Dur.

Insert

The

Insert function (A key) allows the operator to insert a clip into the playlist. The same

operation can be achieved using the

TAKE key.

See also the section 9.9.5 ‘How to Insert Clips into a Playlist’, on page 73.

Speed

The

Speed function (B key) allows defining the speed at which one or all clips of a playlist

will be played. Select the playback speed of the clip with the lever, then press

ENTER to

validate. Values are ‘Unknown’ and from 0 to 100%.
Operators have access to the secondary lever control like when clips are replayed. While

editing the speed of a clip, pressing SHIFT+Lever on the Remote allows to access the

secondary lever speed defined in the menu.

FX Dur

The

FX Dur function (C key) sets the duration of the transition effect. The default value

that initially appears is determined by the value set in the

Setup menu. The effect

duration will affect the transition at the beginning of the selected clip. Use the lever to

adjust the value, then press

ENTER to confirm.

Effect

The

Effect function (SHIFT+C key) is used to select the type of transition effect

(Mix/Wipe/Cut/Fade). Move the lever to set the type of effect, when

Effect is highlighted.

Press

ENTER to validate.

For more information on the effects types, refer to the section 9.14 ‘Transition Effects’, on

page 84.

Delete

The

Delete function allows the operator to quickly edit a playlist by removing the selected

clip. The clip that has been «cut» can then be inserted into another location. This clip is

displayed on the second PRV output. To insert it at another position in the playlist, simply

go to that position using the jog dial and press the

Insert key (or TAKE).