EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 43)

nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.C
35
8.2.3 Recalling a Clip
How to Recall a Clip
To recall a clip, proceed as follows:
1. Select the Clip page 1, 2, 3… to 10 (
PAGE key).
2. Select the bank in which the desired clip is located (the F10 key is reserved for the
playlist bank available on each page).
3. Select the desired clip via the F1 - F10 keys.
Clip Recalled Based on the PREF Setting
If PREF is ON, the preferred camera angle of the clip will appear on the primary channel,
the secondary camera angle on the next controlled channel, then the other camera
angles on the next channels in alphabetical order.
Example: If the preferred camera angle for clip 124 is camera C, when loading the clip,
124C is loaded on the primary channel, whatever the camera present on that channel
before loading the clip.
If
PREF is OFF, when recalling the clip, the camera angle will be the same as the one
who was already present on each controlled channel. If that camera angle does not exist,
the first available camera angle of the clip will be used.
Example: If camera B is the current camera on the primary channel, when calling clip
124, it is 124B that appears on the primary channel, even if it is not the preferred camera
angle.
When the operator is controlling only one channel (such as with
PrvCtl), the clip will
appear at that location only. In the case of a clip containing a single camera angle (only
an «A», «B», «C» or «D» clip), when in full control of all outputs, the clip recalled will
appear on the primary channel.
Toggling Between the Camera Angles
If Recall clip toggle is enabled in the Operational Setup menu (p.9.1 F6), pressing
several times the F_ key will always recall the first frame of the clip, but showing the next
camera angle every time the F_ key is pressed.