EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 35)

nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.C
27
when Multicam is restarted.
The Post-Roll mode works as follows depending on the element played:
• When a clip is played, it will not stop on the Short OUT point, but will continue to play
through the Short OUT point by the Post-Roll duration defined in the Setup Menu.
• When a record train is played, the same will happen if the Record trains OUTs
parameter is set to “Freeze” in the Operational Setup menu (p.2.3 F1).
• When a playlist is played, the Post-Roll will apply only to the last clip of the playlist.
6.1.2 Operational Menu
Rst Cam Sync Prv
Cam A Cam B
CAM A/ B
Rst Cam Sync Prv
Cam A Cam B
If PRV CTL is OFF, select the camera to assign to the PGM output. This camera key will
be highlighted in the menu.
If
PRV CTL is ON, select the camera to assign to the PRV output. This camera key will
be highlighted in the menu.
Rst Cam
Rst Cam Sync Prv
Cam A Cam B
This function restores the position of cameras on the active channels: CAM A on PGM1,
CAM B on PRV.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the RST CAM function.
Sync Prv
Rst Cam Sync Prv
Cam A Cam B
This option allows the user to synchronize the PRV with the timecode and speed of the
PGM output. This function is not available with remote record trains.