EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 20)

Issue
11.01.C
nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
12
Function Keys in the Main Menu
Select the corresponding Function key ( F_ key), and then press ENTER to validate the
selection.
Function Key Use
F1 to F4 If desired, the Multicam system can be run using 1 or 2 EVS
Remote Panels. Depending on the number of play channels
available in the current configuration, 1- or 2- Remote modes
will be available from the main menu.
F1: 1 Remote One Remote Panel is used in the configuration
F2: 2 Remotes Two Remote Panels are used in the configuration.
F3: 3 Remotes N/A.
F4: 4 Remotes N/A.
F5: Char. On/Off Enables or disables the on-screen display (Timecode, Clip ID…)
on the output monitors.
F6: Exit Exits the Multicam software and returns to the EVS Menu.
F7: Clear all clips Clears all clips. All clips will be lost. A confirmation of this
command is required.
For more information to this action, refer to the section 8.2.6
‘Clearing Clips’, on page 37.
Note: This command is not similar to the Clear Video Disks
from the Maintenance menu. If you wish to refresh completely
the server, i.e. to clear all clips including the protected ones, you
need to use Clear Video Disks rather than Clear all clips.
F8: Stop Record Stops the record. The REC key will go off and the F8 function
key is now used to restart the record.
F9: Fill Playlist «Dump» feature which allows all clips to be «dumped» at the
end of the current playlist. This allows the operator to save all
material to tape, as a backup feature after a show is complete.
You can select in the Setup menu which camera angles have to
be included in the Fill Playlist function.
Make sure that the playlist you have selected is an empty one.
This function will append the clips at the end of an existing
playlist.
F0: Technical Setup
menu
Gives access to the technical setup menu.
Important
In order to guarantee the validity of data and clips previously saved, it is advised
to properly exit the application by pressing ALT+Q and ENTER from the
keyboard, or F6 and then ENTER from the Remote Panel. DO NOT TURN OFF
THE SYSTEM WHILE THE APPLICATION IS RUNNING.