EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 26)

Issue
11.01.C
nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
18
4.1.18 GOTO IN / GOTO OUT
When you are in CLIP mode, this key combination enables the operator to go to IN / OUT
points of clips, instantly.
4.1.19 LOOP
It enables the internal Loop mode. The button will flash red in this mode and “LOOP” will
appear on the OSD of the output monitors. When the user selects the Loop mode, the
loop has to be cabled from the HD/SD “clean” output of PGM1 to the Loop In connector.
The loop is performed on the audio and video components of the PGM1 output, or on the
video only, depending on the Internal Loop parameter of the Operational Setup menu,
(p.9.2 F6). In audio embedded, the audio is also looped, whatever the value defined for
the Internal Loop parameter.
To leave the loop mode, you need to press SHIFT+LOOP again.
Note
By default, users have to connect the clean SDI output to the Loop In connector
given that the OSD of the output monitors are not disabled. If users want to use
the output monitor with characters out, they have to start the Multicam
application with the following parameter : /LOOP_SDI_MON.
This is very useful to “consolidate” effects and edits, or adding live sound or music or
voice to previously recorded material when only the video is looped back into the server.
Note
When playing back at 200% in loop mode, then replaying the looped sequence
at 50%, you can obtain a “film effect”.
4.1.20 RETURN
Inside a clip, press the RETURN key to remain on the same picture, but inside the record
train instead of the clip (if that picture still exists in the record train). This is useful when a
clip is too tight and you want to use material beyond the current IN or OUT point.
4.1.21 PAGE
Use this key to select a new clips page. After pressing the SHIFT+PAGE key, you must
press a F_ key to select the corresponding page (1 to 10).