Managing engine clusters, Introduction, Possible actions on clusters – EVS Xsquare Version 2.1 User Manual User Manual

Page 41

3.1.8.

Managing Engine Clusters

Introduction

From the Cluster area of the Orchestration window, you can perform the following actions:

•

add or remove clusters dedicated to a specific job type

•

associate engines to a cluster, or remove the association.

•

define the cluster priority in handling jobs.

Possible Actions on Clusters

Note
When you add a cluster, bear in mind that the cluster position determines the
cluster priority in handling a job type. In other words, if two clusters both handle
the same job type, the cluster located higher in the list will handle that job type in
priority. You can always change a cluster position in the cluster list.

You can manage the clusters via the following actions:

Add a cluster

1. Click the

button in the cluster box located below the position where you want to

insert a new cluster.

2. Select the requested cluster from the list displayed:

The new cluster is added above the cluster box where you have clicked the + button.

USER MANUAL Xsquare 2.1

3. Configuration