EVS Xsquare Version 2.1 User Manual - Manual (Page 27)

2.5.2. Clip Location on an EVS Server
Introduction
When the destination is an EVS server, you can specify which location (page, bank,
position, camera) will be used to store the generated clips on the EVS server. You specify
this in the Location field available by clicking the Lock icon in the Destination column of
the job initiator window.
The following table explains how the application will assign the location based on the
value specified in the Location field.
Basic Rules
The following basic rules are applied:
• If the Location field is empty, the default value 111? is applied:
This means the application uses the first free location starting from clip number 111,
checking all cameras of a clip (interrogation mark) before trying the next clip number.
• Instead of specifying the first clip location, you can specify one or more pages
between square brackets, for example [1;2]?:
This means the application will first search and fill locations on page 1, then 2 (all
camera positions on these pages). It will then search for available locations on other
pages starting with from the lowest page number.
• After the page reference, you can specify a filter on cameras instead of the
interrogation mark, for example [1;2]A: This means only the locations on the
specified CAM (CAM A) will be searched for and filled in. When the locations on the
specified CAMs are all used on all pages, the job will fail and the application will return
an error message.
Detailed Rules
You will find detailed explanations in the table hereafter.
The values based on the patterns explained below can be defined in the Location field
USER MANUAL Xsquare 2.1
2. Job Initiators 21