EVS Xsquare Version 2.1 User Manual - Manual (Page 17)

GUI
Element
Description
Owner field Logon of the user who has created the ScanFolder. Non editable field
only available for users logged as administrators.
+ button
(Add
button) Button that allows users to add a ScanFolder.
- button
(Remove
button) Button that allows users to remove the selected ScanFolder.
Start button Button that allows users to start the ScanFolder service of Xsquare, that
is to say start scanning the ScanFolder, and executing the job when a
file is detected in the ScanFolder.
Stop button Button that allows users to stop the ScanFolder service of Xsquare.
Refresh
button Button that allows users to refresh the window display.
2.3.2. Defining a ScanFolder
Introduction
Adding a ScanFolder will allow you to define the job to be applied to files dropped in the
ScanFolder, that means a given shared folder scanned by the ScanFolder service of
Xsquare.
For the ScanFolder service to take ScanFolder jobs into account, you must start the
associated ScanFolder definition in Xsquare.
Note
See section "ScanFolder Window" on page 9 for additional information on the
field values specified in this procedure.
Prerequisites
Before adding a ScanFolder, you must share the source ScanFolder and the destination
folder.
Procedure
To add a ScanFolder in Xsquare, proceed as follows:
1. Select ScanFolders in the Job Initiators menu.
2. Click the + button at the bottom of the window to add a row for a new ScanFolder.
USER MANUAL Xsquare 2.1
2. Job Initiators 11