ZyXEL Communications P-334WHD - Manual (Page 181)

P-334WHD User’s Guide
Chapter 17 UPnP 181
17.4 Installing UPnP in Windows Example
This section shows how to install UPnP in Windows Me and Windows XP.
17.4.1 Installing UPnP in Windows Me
Follow the steps below to install UPnP in Windows Me.
1 Click Start and Control Panel. Double-
click Add/Remove Programs.
2 Click on the Windows Setup tab and select
Communication in the Components
selection box. Click Details.
Allow UPnP to pass
through Firewall
UPnP broadcasts are only allowed on the LAN. If you block LAN-to-LAN/ZyXEL
Device traffic using the firewall, then you need to select this check box to allow
UPnP-enabled traffic to pass through the firewall.
This setting remains active until you disable UPnP.
Clear this check box if you do not want to create a hole in the firewall for UPnP
application packets (for example, MSN packets).
Apply Click Apply to save your changes back to the ZyXEL Device.
Reset Click Reset to begin configuring this screen afresh.
Table 77 Configuring UPnP
LABEL DESCRIPTION