4 advanced wifi wan screen, Figure 67 wifi wan > advanced – ZyXEL Communications P-334WHD User Manual
Page 118

P-334WHD User’s Guide
118
Chapter 7 WiFi WAN
The following table describes the labels in this screen.
Table 46 WiFi: WPA-PSK/WPA2-PSK
LABEL
DESCRIPTION
Pre-Shared Key
The encryption mechanisms used for WPA/WPA2 and WPA-PSK/WPA2-PSK are
the same. The only difference between the two is that WPA-PSK/WPA2-PSK uses
a simple common password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
Apply
Click Apply to save your changes back to the ZyXEL Device.
Reset
Click Reset to reload the previous configuration for this screen.
7.4 Advanced WiFi WAN Screen
To change your ZyXEL Device’s advanced WiFi WAN settings, click Network > WiFi WAN
> Advanced. The screen appears as shown.
Figure 67 WiFi WAN > Advanced
The following table describes the labels in this screen.
Table 47 WiFi WAN > Advanced
LABEL
DESCRIPTION
Multicast Setup
Multicast
Select IGMP V-1 or IGMP V-2 or None. IGMP (Internet Group Multicast
Protocol) is a network-layer protocol used to establish membership in a
Multicast group - it is not used to carry user data. IGMP version 2 (RFC 2236)
is an improvement over version 1 (RFC 1112) but IGMP version 1 is still in
wide use. If you would like to read more detailed information about
interoperability between IGMP version 2 and version 1, please see sections 4
and 5 of RFC 2236.