ZyXEL Communications P-334WHD - Manual (Page 109)

P-334WHD User’s Guide
Chapter 6 WAN 109
Allow between LAN
and WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN
and from the WAN to the LAN. If your firewall is enabled with the default policy
set to block WAN to LAN traffic, you also need to enable the default WAN to
LAN firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.
Dialup PPP Options
PPP Encapsulation Select CISCO PPP if your dial-up connection uses Cisco PPP encapsulation.
Otherwise select Standard PPP.
Enable Compression Select this check box to turn on stac compression.
Call Control
Dial Timeout (sec) Type the number of seconds for the ZyXEL Device to try to set up an outgoing
call before timing out (stopping).
Retry Count When the ZyXEL Device calls a number, and there is no reply, type the
number of times the ZyXEL Device should keep trying to call the number.
Retry Interval (sec) Type the number of seconds for the ZyXEL Device to wait before trying
another call after a call has failed.
Drop Timeout (sec) Type the number of seconds for the ZyXEL Device to wait before hanging up
the call if it does not receive a positive disconnect confirmation.
Apply Click Apply to save your changes back to the ZyXEL Device.
Reset Click Reset to begin configuring this screen afresh.
Table 42 WAN > Advanced
LABEL DESCRIPTION