ZyXEL Communications P-334WHD - Manual (Page 114)

P-334WHD User’s Guide
114 Chapter 7 WiFi WAN
Figure 63 WiFi WAN > WiFi
The following table describes the general wireless LAN labels in this screen.
Table 44 WiFi WAN > WiFi
LABEL DESCRIPTION
Enable
Wireless
Click the check box to activate WiFi WAN.
To associate
with any
available WiFi
network
Select this option to have the ZyXEL Device connect to any available wireless
network within range.
User Defined
SSID
Select this option to have the ZyXEL Device connect to a wireless network with the
SSID you specified in the Name (SSID) field.
Name(SSID) The SSID (Service Set IDentity) identifies the Service Set with which the ZyXEL
Device will associate. The ZyXEL Device and the access point (AP) must have the
same SSID.
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
network with which the ZyXEL Device will associate. Alternatively, you can double-
click an SSID in the text box below to select that network.
Scan Click this button to have the ZyXEL Device search for available wireless network
within transmission range. The SSID and signal strength are then displayed in the text
box above.
Security Mode Use the same security settings as those on the AP with which you want to associate.
Note: The ZyXEL Device in WiFi WAN Router mode supports only
WEP encryption, WPA-PSK or WPA2-PSK.
Apply Click Apply to save your changes back to the ZyXEL Device.
Reset Click Reset to reload the previous configuration for this screen.