ZyXEL Communications P-334WHD - Manual (Page 123)

P-334WHD User’s Guide
Chapter 8 LAN 123
8.3 LAN IP Screen
Click Network > LAN to open the IP screen.
Figure 68 LAN IP
The following table describes the labels in this screen.
Table 48 LAN IP
LABEL DESCRIPTION
LAN TCP/IP
IP Address Type the IP address of your ZyXEL Device in dotted decimal notation
192.168.1.1 (factory default).
IP Subnet Mask The subnet mask specifies the network number portion of an IP address. Your
ZyXEL Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyXEL Device 255.255.255.0.
Apply Click Apply to save your changes back to the ZyXEL Device.
Reset Click Reset to begin configuring this screen afresh.
8.4 LAN IP Alias
IP alias allows you to partition a physical network into different logical networks over the
same Ethernet interface. The ZyXEL Device supports three logical LAN interfaces via its
single physical Ethernet interface with the ZyXEL Device itself as the gateway for each LAN
network.
To change your ZyXEL Device’s IP alias settings, click Network > LAN > IP Alias. The
screen appears as shown.