ZyXEL Communications P-334WHD - Manual (Page 117)

P-334WHD User’s Guide
Chapter 7 WiFi WAN 117
7.3.3 WPA-PSK/WPA2-PSK
If the access point uses WPA-PSK or WPA2-PSK, select WPA-PSK or WPA2-PSK from the
Security Mode list.
Figure 66 WiFi: WPA-PSK/WPA2-PSK
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the ZyXEL Device and the access point
must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
If you chose 256-bit WEP, then enter 29 ASCII characters or 58 hexadecimal
characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one time.
The default key is key 1.
Apply Click Apply to save your changes back to the ZyXEL Device.
Reset Click Reset to reload the previous configuration for this screen.
Table 45 WiFi: Static WEP Encryption
LABEL DESCRIPTION