ZyXEL Communications Prestige 2602R Series - Manual (Page 62)

Prestige 2602R Series User’s Guide
62 Chapter 3 Wizard Setup
3.1.3 Internet Access Wizard Setup: Voice Configuration
Use this screen to configure the voice settings (for the Prestige’s SIP account one) with the
information from your voice service provider.
Figure 15 Wizard Setup: Third Screen
The following table describes the fields in this screen.
Table 9 Wizard Setup: Voice Configuration
LABEL DESCRIPTION
Active Select this check box to have the Prestige use this SIP account. Clear the
check box to have the Prestige not use this SIP account.
SIP Number Enter your SIP number in this field (use the number or text that comes before
the @ symbol in a full SIP URI). You can use up to 127 ASCII characters.
SIP Local Port Use this field to configure the Prestige’s listening port for SIP. Leave this field
set to the default if you were not given a local port number for SIP.
SIP Server Address Type the IP address of the SIP server in this field. It doesn’t matter whether
the SIP server is a proxy, redirect or register server.
SIP Server Port Enter the SIP server’s listening port for SIP in this field. Leave this field set to
the default if your VoIP service provider did not give you a server port number
for SIP.
REGISTER Server
Address
Enter the SIP register server’s address in this field.
Note: If you were not given a register server address, then
enter the address from the SIP Server Address field
again here.