ZyXEL Communications Prestige 2602R Series - Manual (Page 319)

Prestige 2602R Series User’s Guide
Chapter 33 Firmware and Configuration File Maintenance 319
Figure 196 Telnet into Menu 24.6
1 Launch the FTP client on your computer.
2 Enter “ open ”, followed by a space and the IP address of your Prestige.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “ bin ” to set transfer mode to binary.
6 Find the “ rom ” file (on your computer) that you want to restore to your Prestige.
7 Use “ put ” to transfer files from the Prestige to the computer, for example, “ put
config.rom rom-0 ” transfers the configuration file “ config.rom ” on your computer
to the Prestige. See earlier in this chapter for more information on filename conventions.
8 Enter “ quit ” to exit the ftp prompt. The Prestige will automatically restart after a
successful restore process.
33.3.2 Restore Using FTP Session Example
Figure 197 Restore Using FTP Session Example
Refer to Section 33.2.5 on page 316 to read about configurations that disallow TFTP and FTP
over WAN.
Menu 24.6 -- System Maintenance - Restore Configuration
To transfer the firmware and configuration file to your workstation, follow
the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and SMT
password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-0 is the
remote file name on the Prestige. This restores the configuration to
your Prestige.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Prestige manual.
Press ENTER to Exit:
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit