Table 83 menu 4 internet access setup – ZyXEL Communications Prestige 2602R Series User Manual
Page 247
Prestige 2602R Series User’s Guide
Chapter 24 Internet Access
247
.
If all your settings are correct your Prestige should connect automatically to the Internet. If the
connection fails, note the error message that you receive on the screen and take the appropriate
troubleshooting steps.
Table 83 Menu 4 Internet Access Setup
FIELD
DESCRIPTION
ISP’s Name
Enter the name of your Internet Service Provider (ISP). This information is for
identification purposes only.
Encapsulation
Press [
SPACE BAR
] to select the method of encapsulation used by your ISP.
Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing used by your ISP.
Choices are VC-based or LLC-based.
VPI #
Enter the Virtual Path Identifier (VPI) assigned to you.
VCI #
Enter the Virtual Channel Identifier (VCI) assigned to you.
ATM QoS Type
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify fixed
(always-on) bandwidth. Select UBR (Unspecified Bit Rate) for applications that
are non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty
traffic and bandwidth sharing with other applications.
Peak Cell Rate
(PCR)
This is the maximum rate at which the sender can send cells. Type the PCR.
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source that can
be sent at the peak rate, and a parameter for burst-traffic. Type the SCR; it must
be less than the PCR.
Maximum Burst
Size (MBS)= 0
Refers to the maximum number of cells that can be sent at the peak rate. Type the
MBS. The MBS must be less than 65535.
My Login
Configure the My Login and My Password fields for PPPoA and PPPoE
encapsulation only. Enter the login name that your ISP gives you. If you are using
PPPoE encapsulation, then this field must be of the form user@domain where
domain identifies your PPPoE service name.
My Password
Enter the password associated with the login name above.
ENET ENCAP
Gateway
Enter the gateway IP address supplied by your ISP when you are using ENET
ENCAP encapsulation.
Idle Timeout
This value specifies the number of idle seconds that elapse before the Prestige
automatically disconnects the PPPoE session.
IP Address
Assignment
Press [
SPACE BAR
] to select Static or Dynamic address assignment.
IP Address
Enter the IP address supplied by your ISP if applicable.
Network Address
Translation
Press [
SPACE BAR
] to select None, SUA Only or Full Feature. Please see
for more details on the SUA (Single User Account)
feature.
Address Mapping
Set
Type the numbers of mapping sets (1-8) to use with NAT. See
for details.
When you have completed this menu, press [ENTER] at the prompt “
Press ENTER to Confirm
or ESC to Cancel:
” to save your configuration, or press [ESC] at any time to cancel.