ZyXEL Communications Prestige 2602R Series - Manual (Page 436)

Prestige 2602R Series User’s Guide
436 Appendix K Log Descriptions
2 Use sys logs category to view a list of the log categories.
Figure 265 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 266 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the sys logs save command to store the settings in the Prestige (you must do this
in order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the Prestige’s log.
• Use the sys logs category display command to show the log settings for all of the
log categories.
• Use the sys logs display [log category] command to show the logs in an
individual Prestige log category.
• Use the sys logs clear command to erase all of the Prestige’s logs.
Copyright (c) 1994 - 2005 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit device ether
wan poe config ip
ppp bridge hdap bm
lan dsp voice
ras>
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]
ras>