ZyXEL Communications Prestige 643 - Manual (Page 89)

Prestige 643 ADSL Router
IPX Configuration 6-7
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the [SPACE BAR] to set the value to
Yes, and press [ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options
The table shown next describes the IPX protocol-dependent parameters of the Remote Node Setup.
Table 6-2 Remote Node Novell IPX Options
FIELD DESCRIPTION EXAMPLE
Rem LAN Net # Enter the internal network number of the NetWare server on the remote
LAN. 00000000
(default)
My WAN Net # Enter the network number of the WAN link. If you leave this field as
00000000, your Prestige will automatically determine the network
number through negotiation with the PPP peer. 00000000
(default)
Hop Count This field indicates the number of intermediate networks that must be
passed through to reach the remote node. 1
(default)
Tick Count This field indicates the time-ticks required to reach the remote node. 2
(default)
Please note that the following three fields are only valid for PPPoE encapsulation.
Menu 11.3 - Remote Node Network Layer Options
VPI/VCI (LLC-mux or PPP/PPPoE) Encap:
VPI #= 0
VCI #= 35
IP Options:
Rem IP Addr: N/A
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Multicast= N/A
IP Policies= N/A
IPX Options:
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Dial-On-Query= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL: