ZyXEL Communications Prestige 643 - Manual (Page 68)

Prestige 643 ADSL Router
4-4 Remote Node Configuration
FIELD DESCRIPTION EXAMPLE
Active Choose Yes or No. Inactive nodes are displayed with a
minus sign (–) at the beginning of the name in Menu 11. Yes
Encapsulation PPP refers to RFC-2364 (PPP Encapsulation over ATM
Adaptation Layer 5). If RFC-1483 (Multiprotocol
Encapsulation over ATM Adaptation Layer 5) of ENET
ENCAP is selected, then the Rem Login, Rem
Password, My Login, My Password, Edit PPP
Options and Authen fields are N/A. Moreover, ENET
ENCAP encapsulaton does not apply for IPX routing.
PPPoE (Point to Point Protocol over Ethernet) activates
the fields shown in the above figure. ENET ENCAP
Multiplexing Choose the multiplexing method. Choices are VC-
based or LLC-based. LLC-based
Enter the login name that this remote node will use
when it calls your Prestige. The login name combined
with the Rem Password will authenticate this node. Incoming:
Rem Login
Rem Password
Enter the password used when this remote node calls
your Prestige.
Enter the login name assigned by your ISP when the
Prestige calls this remote node.
Enter the password assigned by your ISP when the
Prestige calls this remote node.
This field sets the authentication protocol used for
outgoing calls. Options for this field are:
CHAP/PAP – Your Prestige will accept CHAP or PAP. CHAP
CHAP – Your Prestige will accept CHAP (Challenge
Handshake Authentication Protocol).
Outgoing:
My Login
My Password
Authen
PAP – Your Prestige will accept PAP (Password
Authentication Protocol).
Route This field determines the protocol that your Prestige will
route. Choices are IP, IPX, IP+IPX or None. IP