ZyXEL Communications Prestige 643 - Manual (Page 52)

Prestige 643 ADSL Router
3-10 Internet Access
FIELD DESCRIPTION EXAMPLE
Remote DHCP Server If Relay is selected in the DHCP field above then enter the IP
address of the actual remote DHCP server here.
Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port.
Table 3-3 TCP/IP Ethernet Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
TCP/IP Setup
IP Address Enter the (LAN) IP address of your Prestige in dotted decimal
notation
192.168.1.1
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the Prestige.
255.255.255.0
RIP Direction Press [ SPACE BAR ] to select the RIP direction. Choices are
Both, In Only, Out Only or None.
Both
(default)
Version Press [ SPACE BAR] to select the RIP version. Choices are RIP-1,
RIP-2B or RIP-2M.
RIP-1
(default)
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 ( IGMP-v2).
Press the [
SPACE BAR] to enable IP Multicasting or select None
to disable it.
None
(default)
IP Policies Create policies using SMT Menu 25 (see the IP Policy Routing
chapter) and apply them on the Prestige LAN interface here. You
can apply up to four IP Policy sets (from twelve) by entering their
numbers separated by commas.
2,4,7,9
Edit IP Alias The Prestige supports three logical LAN interfaces via its single
physical Ethernet interface with the Prestige itself as the gateway for
each LAN network. Press [
SPACE BAR ] to change No to Yes and
press [ ENTER ] to for menu 3.2.1
No
(default)
When you have completed this menu, press [ ENTER ] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ ESC ] at any time to cancel.