Zoom X5V - Manual (Page 45)

Chapter 3: Advanced Setup Options 45
addresses. You need to choose an IP Address that is outside this
range. Normally you should pick the next higher number. For
example, if the range shown is 10.0.0.4 to 10.0.0.15, your Host IP
Address should be the next IP address after 10.0.0.15, which would
be 10.0.0.16. Unless you have changed the X5v’s IP address
settings, which is very unlikely, just use the number 10.0.0.16. Write
down the number you choose for reference if you are not using
10.0.0.16. The rest of the instructions will assume that you are
using 10.0.0.16.
DMZ IP Address: _______________________________
Windows users continue below.
Mac users jump to Step 4 (page 47).
Linux users jump to Step 5 (page 49).
2 2 2 2 Windows Users: Open the TCP/IP Properties dialog
box.
For Windows XP: From the desktop click the Start button, point
to Control Panel and then Network Connections. Then right-
click (NOT left-click) Local Area Connection, select Properties,
highlight your NIC card’s TCP/IP entry (it should start with
TCP/IP and have the characters 10/100, NIC, or Ether in it –
and not have the words AOL, Dial-up, or Adapter). Click
Properties to display the Windows TCP/IP Properties dialog
box.
For Windows 2000: From the desktop click the Start button,
point to Settings and then Network and Dial-up Connections.
Then right-click (NOT left-click) Local Area Connection, select
Properties, highlight your NIC card’s TCP/IP entry (it should
start with TCP/IP and have the characters 10/100, NIC, or Ether
in it – and not have the words AOL, Dial-up, or Adapter). Click
Properties to display the Windows TCP/IP Properties dialog
box.
For Windows 98 and Me: From the desktop click the Start
button, then point to Settings and then Control Panel. Double-
click the Network icon to display the Network configuration
screen. Highlight your NIC card’s TCP/IP entry (it should start
with TCP/IP and have the characters 10/100, NIC, or Ether in it