Xerox 721P85530 - Manual (Page 397)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 180 LPS PDL REFERENCE 8-67
TMODE
This parameter specifies process direction measurement for
determining default pitch mode.
Syntax TMODE = option(s)
Options Table 8-57 lists the parameter option(s) and definition(s).
TOF
This parameter specifies the top-of-form line number. It takes effect
at the next record following a DJDE END. The value parameter is
defined the same as in the VFU command as defined in the chapter
"Print format commands."
Syntax TOF = option(s)
Options Table 8-58 lists the parameter option(s) and definition(s).
Table 8-61. TMODE parameter option(s) and definition(s)
Option(s) Definition(s)
( width [,width
unit])
This option has the following components:
•
width
The process direction measurement that
determines the default pitch mode.
• width unit
Can be IN, CM, DOTS, or XDOTS. The
default is IN.
Width values can range from the 7-inch
equivalent to the 17-inch equivalent.
Table 8-62. TOF parameter option(s) and definition(s)
Option(s) Definition(s)
value Specifies the number of lines from the top of the
output page to the first print line on the page (top
of form). The top-of-form specification is
independent of channel assignments. It should be
greater than or equal to 1 and less than or equal to
the smallest line number assigned to a channel.
The default is 1.