Xerox 721P85530 - Manual (Page 380)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-50 XEROX DOCUPRINT 180 LPS PDL REFERENCE
MARGIN
This parameter specifies the left printing margin within each logical
page. It takes effect at the logical page following a DJDE END
parameter. The parameters are the same as in the LINE command
defined in the chapter "Print format commands."
Syntax MARGIN = option(s)
Options Table 8-37 lists the parameter option(s) and definition(s).
Table 8-41. MARGIN parameter option(s) and definition(s)
Option(s) Definition(s)
{ value|
( value, value-
type)}
This option has the following components:
• value
The form
nnn.mm (a positive decimal number
with up to 2 digits to the right of the decimal
point) which is the distance from the left
margin.
•
value-type
Indicates whether a value is specified in
inches (IN), centimeters (CM), or character
positions (POS). A value must be specified as
an integer (
nnn), if a value-type is character
positions.
The default is (1,POS).
Refer to the "Points to note" for the VOLUME
command in the chapter "Specifying input
parameters" for additional information.