Xerox 721P85530 - Manual (Page 102)

SPECIFYING INPUT PARAMETERS
4-14 XEROX DOCUPRINT 180 LPS PDL REFERENCE
Table 4-18. ASSIGN parameter option(s) and definition(s)
Option(s) Definition(s)
( byte,(ccln
1
,
[ ccln
2
][,...])
This option has the following components:
• byte
The printer carriage control byte being defined. Its value is in the range 0 to
255 (X00 to XFF).
• ccln
Specifies the action that should be taken when the printer carriage control byte
defined in byte is encountered. A
ccln may be any of the following definitions:
— TOF
When
byte causes the bottom-of-form (BOF) to occur, instructs the
printing system to go to the top-of-form (TOF) on the next page and to
stop spacing.
— IGN
When
byte causes the bottom-of-form (BOF) to occur, instructs the
printing system to ignore it to continue spacing through the end of the
physical page. The page then transitions to top-of-form and spacing
continues.
— OVR
When
byte causes the bottom-of-form (BOF) to occur, instructs the
printing system to go to the top-of-form (TOF) on the next pate and to
continue spacing.
The default is OVR.
• Space print parameters - This has the following components:
Each of the three fields is optional; however, you must specify at least one
field. The range for the variables m and n is 0 to 15.
— field
1
Specifies the carriage action to take before printing. An example is the
ANSI carriage control:
– SP m
Space m lines before printing.
– SK n
Skip-to-channel- n before printing.
— field
2
Specifies whether printing occurs for this record:
– P
Print the output data at the line number computed after field1 is
processed.
– N
No printing occurs for this record (default).
— field
3
Specifies the carriage action to take after printing. An example is the
IBM1403 carriage control).
– SP m
Space m lines before printing.
– SK n
Skip-to-channel- n before printing.