Xerox Phaser 3100MFP/X - Manual (Page 26)

Phaser 3100MFP/X
- 21 -
2 - Installation
Output Support Tab
Adjust the paper output support tab depending on the size
of the document to be printed. Do not forget to raise the
flap to prevent output sheets from falling out of the
machine.
Starting your device
Device connection
1 Plug the end of the telephone line into the machine
socket and the other end into the wall telephone
socket.
2 Make sure that the On/Off switch is on Off
(O position).
3 Connect the power cord to the device.
Plug the power cord into the wall outlet.
4 Press the On/Off button to turn on the device
(I position).
Device initial setup
After a few seconds, when the machine has warmed up,
the Easy Install function is launched and the LCD screen
displays the following message:
The Easy Install function will help you configure your
machine by guiding you through the basic settings.
If you wish to modify the setting displayed, press the OK
button. If you do not want to modify the displayed setting,
press the C button: the Easy Install function then
displays the next basic setting.
1 To modify the display language, press the OK
button.
2 Select the desired language using the or
buttons and confirm with OK.
3 To set the country, press the OK button.
WARNING
Before plugging the power cord, it
is imperative to refer to the
Security directives, page 9.
WARNING
The power cord is used as a power
unit cut off. As a precaution, the
outlet shall be located close to the
device and be of easy access in
case of danger.
SET LANGUAGE
YES=OK - NO=C
Note
If you do not want to carry out the
initial setup, press the button. A
confirmation message appears. Press
the button again to confirm.
To manually modify and customise the
machine settings, refer to
Parameters/Setup, page 36.
SET COUNTRY
YES=OK - NO=C