Tandberg Data T40 User Manual

Page 87

StorageLibrary Installation and User Guide

Shipping or Transporting StorageLibrary

Reinserting the Transport Locking Screws

If you need to move or ship the StorageLibrary you need to reinstall the transport locking screws to
protect the robotics. The screws fasten the robotics to the chassis and hold the robotics in a locked
position. Use the instructions below to reinsert the transport locking screws.

1. Locate the transport locking screws. They are stored in the rear of the unit and they are marked

with red plastic tabs (four M3x6 mm screws).

2. From the FPI select Menu > Tools > Prepare to ship and follow the instructions displayed on the

FPI screen. The robotics will automatically be moved to the lower front position, and the
magazines will pop out.

3. Remove the magazines.

4. Remove all cartridges from all the magazines.

5. Turn off the power switch on the rear of the unit.

6. Install the four transport locking screws. The screws fasten the robotics to the front chassis. The

transport locking screws are screwed into the robotics from the front of the library, two on each
side of the front bezel. See

Figure 25. Transport Locking Screws Marked with Red Plastic Tab

7. If installed, remove the rack mount ears. If your library is a 24 slot version you need to remove the

two upper magazines by using the emergency eject tool. See

Manual/Emergency Release of

Magazines

8. Reinsert all magazines.

9. If you need to ship the unit, use the original packaging.