Tandberg Data T40 - Manual (Page 81)

StorageLibrary Installation and User Guide 73
Table 9. Troubleshooting Matrix Power with Solution
Problem Solution
Power
Library does not power on Check the power cord connection.
Make sure the power switch on the rear panel is in the ON
position.
Make sure there is power to the outlet. Try another working
outlet.
Replace the power cord.
Make sure that the fuse located beside the power connector
on the rear panel is not blown. Replace fuse if blown (a spare
fuse is located behind the fuse door).
Verify that the power supply unit is properly inserted into the
bay.
Replace the power supply unit.
Contact your service representative.
The display is dead Power cycle the library by turning off and on the main power
switch on the rear of the library.
Verify that the fans start at power on and then stops after a
few seconds.
Check the power cord connection.
Make sure the power switch on the rear panel is in the ON
position.
Make sure there is power to the outlet. Try another working
outlet.
Replace the power cord.
Make sure that the fuse located beside the power connector
on the rear panel is not blown. Replace fuse if blown (a spare
fuse is located behind the fuse door).
Verify that the power supply unit is properly inserted into the
bay.
Replace the power supply unit.
Contact your service representative.
The front panel does not
display information but the back
light on the front panel is on Power cycle the library by turning off and on the main power
switch on the rear of the library.
Verify that the fans start at power on and then stop after a few
seconds.
Contact your service representative.