Tandberg Data T40 - Manual (Page 12)

4 Product Overview
Channel and SCSI tape drive interfaces within the same library. LTO Fibre Channel tape drives can
be directly attached to hosts or the SAN. LTO SCSI tape drives are attached directly to the host.
Tape drives are installed into tape drive bays in the rear of the library. If a tape drive bay is empty, a
cover plate covers the empty tape drive bay to prevent dust from entering the library. Tape drives can
be installed in any available tape drive bay.
Data Transfer Rates
Table 1. Data Transfer Rates
StorageLibrary
Model Maximum Sustained Rate,
Native Maximum Sustained Rate, Compressed
LTO-3 SCSI 80MB/s 160MB/s
LTO-3 FC 80MB/s 160MB/s
LTO-4 SCSI 120MB/s 240MB/s
LTO-4 FC 120MB/s 240MB/s
Magazines
The library is equipped with four removable magazines, all accessible from the front of the unit. The
lower magazines hold 12 cartridges each and the two upper magazines hold 8 cartridges each. There
are no hidden slots. To cool the library, there are air inlet holes on the bezels. For easy removal of the
magazines, use handles on the sides of the bezels. For details on magazine handling, see the section
Magazine Handling .
Front Panel
The Front Panel includes the Operator control panel with LCD display, four control buttons, two LED
indicators and a standby switch. The bezels of the four magazines are also visible from the front.
Figure 1. Front Panel of the StorageLibrary
LCD Liquid Crystal Display
The display is a backlit 128 x 68, dot-matrix graphical display that can show 8 lines of 20 characters.
In various modes of operation, the display panel screens and control buttons allow you to do the
following:
Enter settings for StorageLibrary configuration.